Azuro OXI shock 0,6 kg

Product detailed description

Instructions for use:
Adjust the pH to 7.0-7.4 before using the product for the first time. During the first water treatment and as a shock measure approx. dose 20-40 g/1m3 of water every 2 weeks. Add more product as needed while the whirlpool is running. In general, to achieve crystal clear and permanently hygienic water, the pH value should be maintained in the range of 7.0-7.4 and the active oxygen content should be maintained in the range of 8-12 mg/l, at water temperatures above 28 °C active oxygen concentration between 10-14 mg/l. If the content of active oxygen falls below the value of 8 mg/l, it is necessary to add another dose of the product, if it is higher than 14 mg/l, limit the dosage of the product and wait until this value falls within the above range. The product is acidic in nature, so it will reduce the pH value and alkalinity. When using it, it is therefore necessary to regularly monitor not only the active oxygen content, but also the pH and alkalinity of the water at least once a week.

Method of application:
Completely dissolve the dose of the product in water in a clean plastic bucket. THE PREPARATION IS ESSENTIALLY ADDED TO THE WATER AND NOT THE VERSA! Slowly pour the dissolved product directly into the whirlpool. The filter equipment must be in operation during and 24 hours after the application.
Note: The above information is for informational purposes only. Read the instructions for use carefully before application!!!
Use biocidal products safely. Always read the information on the package and the attached product information before use.

Weight: 0,6 kg